Clean and Dry: Cleaning and drying hands at a stainless steel basin

Personnel hygiene starts with cleaning hands.

Further information on the products shown here can also be found in our hygiene brochure which you can request in digital or printed form here.

Cleaning basin, type 20580 Clean and Dry

Cleaning and drying hands at a stainless steel basin

With integrated hand drying technology from Dyson Airblade Tap, hands can be dried at the sink in just 12 seconds. A separate hand-drying area is unnecessary which prevents dripping onto floors and improves hygiene.

Water and air is supplied contactless – users do not need to touch the outlet. Intelligent infra-red sensors generate light to determine the precise positioning of hands. A highly effective HEPA filter removes
99.9 % of all air-borne bacteria and viruses before they reach the hands.

Contactless operation means water is consumed only when hands are held under the outlet. This reduces water consumption and operating costs.

• Hygienic design with a stainless steel rear panel and finely  finished hygienic surfaces. 

• The integrated Dyson AIRBLADE™ Tap, a sensor fitting with an integrated hand dryer, enables hand cleaning and drying directly at the basin in just 12 seconds.  

• No extra hand-drying space required and no splashes onto floor surfaces.

• Both water and air is controlled by a sensor so no contact is necessary to outlet fittings or control buttons.

• Water consumption is reduced significantly.

• Cleaning troughs with two and three Dyson AIRBLADE™ Tap also available.


• 12-second drying time  
• A HEPA filter to remove 99.9 % of bacteria from the hand drying air 
• Low operating costs  HACCP certified  
• Low CO2 emissions  
• No splashes on floor surfaces  
• Non-contact operation  
• Reduces water consumption via sensor-controlled water flow 

Further information about
Dyson Airblade™
(external Link)