Sole cleaning in combination with controlled hand desinfection

Sole cleaning in pass through procedure with the Solo-Dynamic type 23860 in combination with INLET CONTROL type 23740.
The placement of the machine is possible also in small passages.
Cleaning detergent and water are brought by separate pipes and mixed on the brushes. Rinsing with clear water follows the addition of cleaning detergent.

The Hygiene station type 23874-E-500 can be directly integrated into the process chain of a systematic personnel hygiene concept.

The sensor-operated hand cleaning basin which can be integrated into the Hygiene station type 23874-E-500 offers the lowest contamination risk by avoidance of direct contact during the water request.

Low water and energy consumption ensure a maximum of economic efficiency.

500 mm roller brushes ensure efficient cleaning and disinfection of soles. The spiral-shaped bristles increase the effectiveness of the mechanical cleaning and an optimal contamination removal.

Star-Clean type 23874-E-500 with washing basin, soap dispenser, folding hand towel dispenser and Mano Control (see photo above)

For a fast and safe hand disinfection the Mano Control type 23745 can be easily mounted on the Hygiene station type 23874-E.  (see photo below)

• with additional hand rail
• sole cleaning module with brush length of 1000 mm

• with mechanical turnstile
• sole cleaning module with brush length of 500 mm

• with mechanical turnstile
• sole cleaning module with brush length of 1000 mm

• with Mano Control Type 23745
• sole cleaning module with brush length of 500 mm

• with Mano Control Type 23745
• sole cleaning module with brush length of 1000 mm

STAR CLEAN type 23882-III
with sole cleaning module with brush length of 1000 mm and Inlet Control type 23740

The different variants of the Modular Hygiene Station STAR CLEAN can be matched exactly to your operational requirements and can be directly integrated into the process chain of systematic staff hygiene.

Speedy process because of simultaneous disinfection of hands and soles. Walk through capacity (entry): up to 25 persons per minute

The specially shaped “floating“ step guidance (Pentagon) and the optimised step width ensure that water as a result of the rotation of the cleaning bristles does not splash uncontrolled. The “floating“ step guidance leads to a better machine hygiene because the deposition of dirt particles is minimised and enables a fast and effective cleaning.

The machine can be installed as platform model or can be built into a pit at ground level.

• sole cleaning module with brush length of 1600 mm
• INLET CONTROL type 23740

Due to the modular construction method it is possible to combine different STAR-CLEAN variants with different sole cleaning and disinfection sections.

STAR-CLEAN type 23891

Hygiene sluices for optimal guide of personnel at production entrance and exit.

All functions such as reaction time operation time of the brushes dosage intervals and concentration can be set individually by the integrated circuit microprocessor.

for the most frequently used accesses.
Double entrance to the production area for the most frequently used accesses. Optionally the machine can also be used for leaving the production area.